Measure:
1. Outside to outside of the ROPS--NOTE: If the ROPS are a folding
ROPS measure outside to outside above the joint.
2. If your ROPS is a folding ROPS measure from the hinge bolt to the
top of the ROPS
3. Measure the tubing that the ROPS is constructed with. For example:
if the tubing is 2 3/4" X 3 1/2" or other.
4. If the ROPS tilts forward measure the degree of tilt on the forward
side by using a 12" string. Press the string to the ROPS and let the
string hang straight down like a plumb bob and measure from bottom
of string back to the ROPS. For a backward tilt of the ROPS press the
string to the backside of the ROPS and measure the same way. If your
ROPS is a folding ROPS take this measurement of the ROPS above
the hinge point.
Frequent asked question:
Note: Forward tilt is going towards the front of tractor.
Backward tilt is towards the back of tractor.
Send these measurements by e-mail with tractor make and model to
admin@tractor-canopies.com